Raedian NEX AVIA VOLT
Content languageEnglish
Description
This template provides the integrating the AVIA VOLT AC Wallbox Readian NEX using the Modbus TCP protocol. The template includes the necessary Modbus registers and configuration settings required for seamless communication between the wallbox and the miniserver.
To put the wallbox into operation, the raedian install app is required!
The wallbox works with LAN and WLAN. It is necessary to assign a fixed IP address to the wallbox. This can also be managed in the raedian install app.
The maximum charging current depends on your grid capacity and the installed fuse for the wallbox.
Note: Valid number of charging current for Mode 3 EV charging is from 6 Ampere to 32 Ampere. Setting charging current limit between 0 to 5999 will set the charger to pause charging session, setting back to 6000 to 32000 will resume the charging session.
Template by bingesser huber elektro ag
Inputs and outputs · 18
| Name | Type | Unit |
|---|---|---|
| Serial Number | Modbus | <v.1> |
| Firmware version_ | Modbus | <v.3> |
| Max rated/settable current | Modbus | A |
| Charging state | Modbus | <v> |
| Current charging current limit | Modbus | A |
| Voltage phase 1 | Modbus | V |
| Voltage phase 2 | Modbus | V |
| Voltage phase 3 | Modbus | V |
| Active power | Modbus | kW |
| Energy delivered in charging session | Modbus | kWh |
| Cable lock | Modbus | <v> |
| Fehlercode | Modbus | <v> |
| Charging current phase 1 | Modbus | A |
| Charging current phase 2 | Modbus | A |
| Charging current phase 3 | Modbus | A |
| Set charging current limit | Modbus | A |
| Set charging phase(in roadmap) | Modbus | <v> |
| Start/Stop Charging Session | Modbus | <v> |
Ratings and comments
No ratings or comments yet.
Log in to rate, comment or ask a question. Log in