ONOKOM AIR MH-2-MB-B
Content languageEnglish
Description
This template allows you to connect any Mitsubishi Heavy air conditioners supported by the ONOKOM MH-2-MB-B gateway to the Loxone system via Modbus RTU.
Inputs and outputs · 13
| Name | Type | Unit |
|---|---|---|
| Indoor air temperature | Modbus | °C |
| Outdoor air temperature | Modbus | °C |
| AC connected (Status) | Modbus | |
| Vertical vanes (Status) | Modbus | <v.1> |
| Horizontal vanes | Modbus | <v.1> |
| Active (Control) | Modbus | |
| Loxone modes (Control) | Modbus | <v.1> |
| Smart fan speed | Modbus | <v.1> |
| Target temperature | Modbus | °C |
| Vanes swing | Modbus | <v.1> |
| Modbus address (Service) | Modbus | <v.1> |
| Vertical vanes (Control) | Modbus | <v.1> |
| Horizontal vanes | Modbus | <v.1> |
FAQ
No questions have been answered yet.
Questions and answers
MHI Integration Loxone
OpenDear,
I have the following Mitsubishi Heavy Industries units with a customer:
2x SRK20ZS-WF 1x SRK35ZS-WF 1x SRK50ZS-WF
Are these also compatible with the ONOKOM AIR MH?
I cannot use the LOX AIR modules, since they don't have the interface cards (to bring the 'X' and 'Y' connectors outside). This would then end up with a total cost of 1600 EUR, just for the integration.
I am therefore looking to use alternatives, that can use the 'CNF' output on the Main PCB to integrate with Modbus in any way.
I saw your module was for MHI devices, but not sure if it can be used for these ones.
Many thanks in advance for your help.
Kind regards, Kristof Geerts
No replies
Log in to rate, comment or ask a question. Log in
Ratings and comments
No ratings or comments yet.
Log in to rate, comment or ask a question. Log in